Applies To Product(s): OpenPlant Modeler Version(s): 08.11.11.87 Environment: Windows 7 (64 bit) Area: Component Subarea: Data Original Author: Deepak Singh, Bentley Product Advantage Group In OpenPlant Modeler, to modify Stem Diameter of Hand wheel Background In OpenPlant Modeler for hand wheel, a user can modify hand wheel length (HANDWL_LEN) and diameter (HANDWL_OD) but there is no any option to modify the Stem Diameter of the hand wheel. The value of stem diameter is hard coded in the code and it’s dependent on the Wheel Diameter. Steps to Accomplish Open a metric spec mEX-OPM. Go to TOPWORKS table. Filter the parameter as shown and inspect the HANDWL_OD & HANDWL_LEN. In OpenPlant Modeler place a HAND_WHEEL of main size 100. Referring to spec there is no any fields from where the value 38.10 is populating. The Stem Diameter value is populating using the following relation. Stem Diameter = Wheel Diameter / 6. Stem Diameter = 228.60 / 6 = 38.10 In spec.mdb copy an existing row have a revision 1 and change the HANDWL_OD to 300. In OpenPlant Modeler place HAND_WHEEL of HANDWL_OD 300 and check the Stem Diameter. See Also Still a Problem? If above problem still persist, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround. Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧
