Does anyone else have problems with gear operators in OPM rotating in the wrong axis on placement? In OPM 08.11.09.581, we have an issue where placing a gear operator at any angle other than straight up will cause the valve operator to either rotate along the pipeline instead of around it, or flip to the other side of the valve. I can't test this in the out of the box version because there isn't a spec for gear operators. Here, I chose the gear operator and clicked the valve. Then I set the angle to 45 degrees. The operator points along the valve instead of rotating around the valve. It's not a huge deal as we can insert the operator straight up and rotate it afterwards, but I'm wondering if there is a setting in our config that controls this rotation or if it's built into the program.
↧