Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX(SS5) | 08.11.11.87/103 (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Open/Save Subarea: Installation Original Author: Abhijit Bute, Bentley Product Advantage Group Background OpenPlant Isometrics Manager installation can be done for both OpenPlant Modeler and AutoPLANT Modeler. During the installation user need to select the correct option provided for each product. Following are the steps for installation for both application, OpenPlant Modeler - OpenPlant Isometrics Manager & AutoPLANT Modeler-OpenPlant Isometrics Manager. OpenPlant Modeler - OpenPlant Isometrics Manager Steps to Accomplish After installation of OpenPlant Modeler, Run OpenPlant Isometrics Manager exe. See step by step procedure. Note - Check OFF AutoPLANT Database Mode option when installing it for OpenPlant Modeler side. Click on Finish and OpenPlant Isometrics Manager is ready to use along with OpenPlant Modeler. AutoPLANT Modeler - OpenPlant Isometrics Manager Steps to Accomplish After installation of AutoPLANT Modeler, Run OpenPlant IsometricsManager exe. See step by step procedure Note - Check OFF OpenPlant ModelServer Mode option when installing it for AutoPLANT Modeler side. Click on Finish and OpenPlant Isometrics Manager is ready to use along with AutoPLANT Modeler. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧
