Is there somewhere in the schema / cells / settings where this can be changed, for what we are doing and others, to limit the pipe length like this makes placing arrows hard at times? Using the formula above for a DN500 pipe Flow Arrow Length = 1.5 x 500 = 750mm Minimum to allow flow arrow = 750 x 2 = 1500mm or 3 x 500 = 1500mm In many cases we have piping where it is mainly fitting to fitting with lengths of pipe shorter then 1500mm, the result is we cannot place flow arrows on the line. Due to this we have to manually alter the Isometric to show a flow arrow, not desirable for an automated system. Thanks Ray
↧