Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX (SS5) | 08.11.11.XXX (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Iso Processing Subarea: - Original Author: Deepak Singh, Bentley Product Advantage Group Problem Description I-model doesn’t load in OpenPlant Isometrics Manager. Reason User has created a new associated item for pipeline as “Lines Number” refer image below. Also, Associated Item Relationship custom attribute for this item is defined in supplemental schema as shown below. The schema location for this custom attribute must be in OpenPlant_3D.01.07 schema. Steps to Accomplish Using Bentley Class Editor, open OpenPlant_3D.01.07. ecschema of your project. Supplement above schema with OpenPlant_3D_Supplemental_Modeling.01.07. ecschema & OpenPlant_3D_Supplemental_ModelingViews.01.07. ecschema. Also supplement that schema, in which schema location for newly created associated item is defined. Here schema location of Associated Item Relationship custom attribute for newly created associated item is OpenPlant_3D_Supplemental_AFW_Custom_Attributes.01.00 Supplemented schema list for OpenPlant_3D.01.07. ecschema are as shown below. Navigate to ASSOCIATED_ITEM_LIST_FOR_PIPING_NETWORK_SYSTEM class, switch to properties tab as shown below. Select newly associated item, here “LINENO” & scroll down to Associated Item Relationship custom attributes. Notice that schema location defined for this property is not in OpenPlant_3D as shown. Click on LINENO & select Custom Attributes > Add/Remove as shown below. Change schema location to OpenPlant_3D.01.07 as shown below. Save all the changes. Create some modeling arrangement in OpenPlant Modeler, publish i-model & load i-model in OpenPlant Isometrics Manager to verify the result. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧