Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.xxx Environment: Windows 7 (64 bit) Area: Settings/Attributes Subarea: Isometrics Generation Original Author: Rahul Kumar, Bentley Product Advantage Group Overview OpenPlant Isometrics Manager fixes the swapping of Sheet No & No of Sheets. Problem Description In user’s customized environment, requirement was to show Sheet no of No of Sheets. i.e. like 1 of 2, 2 of 2. During Isometrics generation the sheet no & no of sheets reversed the order as 1 of 1, 2 of 1 etc. Also see intermediate file it has been written. Below are the solution offered to user get the correct results. Reason During workspace setup process on user’s machine (Standalone mode), it has been found that MS_DEF variable was commented out in project pcf file. See image below. This has been used to define the default location of project DGN file. Removing “#” sign from this variable solves the problem. See image below. Solution offered to user was purely based on user environment & his setup. The content has been written to demonstrate the possibilities & fixes which user can refer fixing such problems. This type of errors might occur based on use cases which will get added later in this article. Still a Problem? If above problem still persist, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧