Hello DongYeong Kim, Please check below possibilities on each of your concern. A. On Selection of Pipeline - To preview Pipeline on selection, you can check the information displayed on message center. See image below. Regarding automatic selection of desired pipeline, you can use Auto Match option while modeling & it will give pick the pipe automatically when connected to desired pipeline. \ B. To Change default Device Type Code value to Service. You can either modify it inside OpenPlant Modeler. See below steps. Open Primary schema, i.e. OpenPlant.01.07.ecschema. See default path below. Supplementing it by OpenPlant_Supplemental_Tagging.01.07.ecschema. Search for FLUID_REGULATOR class and check for NAME property under Property tab. Modify expression as shown below. Also modify parser regular expression to allow fields to automatically update values. Save & Close schema. Launch OpenPlant Modeler and verify results. See image below. Alternatively, you can also customize the labels inside OpenPlant Isometrics Manager using User Label option present inside isometric configuration. Refer below wiki article for similar issue. With reference to above article, you can write any expressions. In your case it should be this.SERVICE & "AA" & this.NUMBER. Add it inside Specific BOM Labels custom attributes and verify results. HTH -Regards | Rahul Kumar
↧