Forum Post: RE: OPIM SS6 U3 - Prerequisite and Common Tools for AutoPLANT Applications requirement

Hello, Thanks for your question, while installation of openplant isometric manager their is not need to install Autoplant Prerequisites. if your windows not updated then you need install Desktop Prerequisite Pack v08.11.09.03 refer below readme file notes. Installation for AutoPLANT OpenPlant Isometrics Manager V8i (SELECTseries 6) must be installed with AutoPLANT V8i (SELECTseries 8) or higher. OpenPlant Isometrics Manager can be installed in any order with AutoPLANT i.e., either before or after AutoPLANT application The required AutoPLANT applications installed with OPIM depend on how the user would like to use the isometrics product: If the user wants to use OPIM from within the AutoPLANT Plant Modeler application, then the obvious choice would be to install AutoPLANT Plant Prerequisites and AutoPLANT Plant Modeler alongside OPIM If the user wants to use OPIM outside of the AutoPLANT Plant Modeler application, then the user can just install AutoPLANT Plant Prerequisites and Common Tools alongside OPIM. Also please refer following link for Readme file refer Installation Instruction communities.bentley.com/.../272616 Regards, Abhijit Bute