Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX Environment: Windows 7 (64 bit) Area: Component Subarea: Original Author: Kestutis Mitkus, Bentley Product Advantage Group Background In OpenPlant Modeler, users requirement is to see Nozzle Facing Property in Element Information dialog. Steps to Accomplish Load OpenPlant_3D.01.06 schema in class editor, supplement it with OpenPlant_3D_Supplemental_Modeling.01.06 and OpenPlant_3D_Supplemental_Modeling_Views.01.06 schema. Go to property section of NOZZLE class, find RATING property, right click and do copy/paste. Edit RATING1 as FACING and change OpenPlant_Physical_catalogue_Property_Map custom attribute values as in below picture. Save all changes and close Bentley Class Editor. Start OpenPlant Modeler, place new Nozzle and check FACING Property under Operating Conditions category in Element Information dialog. See Also Comments or Corrections? Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧