Applies To Product(s): OpenPlant Support Engineering Version(s): 08.11.11.87 (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Component Subarea: Support Placement Original Author: Rahul Kumar, Bentley Product Advantage Group Background In OpenPlant Support Engineering, user tries to use OpenPlant Modeler file and place a support on it. Further this can get published in to i-model to generate an isometric. See below steps for correct procedure on working with OpenPlant Modeler-OpenPlant Support Engineering. Steps to Accomplish Create a model inside OpenPlant Modeler Create iso sheets and publish an I model. Launch OpenPlant Support Engineering. Select OPModeler_Metric here. Create New file Attach an I model file as reference file. Place supports on a pipeline, say Pipe Clamp Shoe and Single UBolt here. See below arrangement. From File -> Save. Publish an i-model to it. Launch OpenPlant Isometrics Manager. Select I model generated from OpenPlant Support Engineering. Verify Results. Notice support placed on iso correctly. Also check BOM reports. Note - In case of i-model updates, please refer here>>>> . See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧