Applies To Product(s): OpenPlant PID Version(s): 08.11.10.XXX & Higher Environment: Windows 7/8/10 (64 bit) Area: Placement Subarea: Original Author: Harpreet Singh, Bentley Product Advantage Group Problem Description Sometimes below error appears in the message center when new/existing file is opened or when trying to place a component in the drawing. Since this error message doesn't tell much about the actual problem so we will change the log level. Go to Workspace > Configuration and change the log level to -1 as shown below. Again check the error in message center. As highlighted below, there is a problem in reading the schemas mentioned in error message. Steps to Resolve To further investigate open the 'OpenPlant_PID' schema in class editor. Below error message appears and schema doesn't open. Open the schema in NOTEPAD and find Bentley: Transform3D. Two entries are found in the schema with this keyword. In CABLE_CORE class In IO_CHANNEL Remove both entries from schema and save it. Again try to open the schema in class editor and supplement with OpenPlant_PID_Supplemental_Imperial schema. This time below error message appears while supplementing the schema. Open the schema in notepad and find 'PIPE_LINE_INSULATION_ANNOTATION'. This class is defined twice in the schema which is causing the issue. Delete below highlighted portion from schema and supplement again. Save the changes in schema and launch OpenPlant PID to verify the result. Still a Problem If there is still some problem while trying to perform any operation against OpenPlant PID, then please create a Service Request and contact Bentley Product Advantage group along with the list of all relevant details to get in depth analysis and for possible solution or workarounds. Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧