Hello Deepak, Thanks for your concern. Creating support assembly does not require any complex scripting. Multiple users requested similar type assembly creation as paid services. Also you may request it via admin training for OpenPlant Support Engineering and further create such custom assemblies based on existing supports or by creating new supports. Though majority of supports has been covered through shipped catalog, by using it you can create assemblies. In case you may require any exceptional support assemblies then you may contact Bentley's professional services to provide the same for your organisation. OpenPlant Modeler does provide basic supports and generic supports to place, but for any complex geometries and specific procedure should get attended via OpenPlant Support Engineering. Hence it is always advisable for its use. I will certainly pass this over to PS team to contact you if any difficulty in implementing it via OpenPlant Support Engineering. However you may also write to OpenPlant Product Management team Rob.harper@bentley.com & abbas.ali@bentley.com Also we are regularly contributing tech article on OpenPlant Support Engineering, which you and your team may find useful in implementing. HTH -Regards | Rahul Kumar
↧