Hi Harpreet, thanks you for the fast reply. Step 1: I create a piping model with OpenPlant Modeler V8i (SELECTseries 5). This is model is not in true position. Step 2: My Civil Technicians make a container model attaching the piping, structural, electrical models, ect Using AECOsim Building Designer V8i (SELECTseries 5). Step 3: They then move all of our models to the correct location in the world. (This is happening in the container) Once they run their extractions everything comes out fine except OPM piping/equipment. Its putting the piping back at the coordinates it was modeled at in my piping model. So i tried modeling the pipe at true position and had civil rerun their extractions and the pipe did show up. So my question is modeling our facilities at true position the road we have to take, or is there a way around this? Thank you so much for your help.
↧