Hello Stephen, I can see the Long description for both 150LB and 300LB gasket is same. If you add ratings in long description for both gasket you would not face this kind of problem. If you want to use same description following workaround will help you to get different part id for 300LB and 150 LB gasket. 1. Open Class Editor. 2. Navigate to project path. 3. Open "OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04 schema". 4. search for Gasket class. 5. Add "&this.RATING" Refer below image. 6. Save the schema. 7. Reopen AutoPlant Modeler generate isometric. Hope this helps. Looking forward to your reply. Regards, Abhijit Bute
↧