Quantcast
Channel: OpenPlant | AutoPLANT
Viewing all articles
Browse latest Browse all 12277

Forum Post: RE: Dummy Lag Support - Origin Location

$
0
0
Hi Kestutis, Thanks for the response, will OP Support Engineering give me the correct length of the dummy leg on the Isometric when it is run? I'm thinking no would be the answer to that. If not then I will just modify the ISO after it is run, not the best way to do things. I noticed that there is a length property in this support, but I'm not sure what it is calculating so that is not of use either, I put in different diameter supports and I get the same length value. I will put in a SR so this can be fixed. Ray

Viewing all articles
Browse latest Browse all 12277

Trending Articles