Hello Ray, In OpenPlant Modeler - OpenPlant Isometrics Manager, with current release it can be managed using Component Tag attribute IE_OPDIR . See image below. This is further controlled under User labels Option. See image below. See results in OpenPlant Isometrics Manager: However with version 08.11.09.440, You wont find this attribute. Hence you need to customize schema by creating a property with value to be used as SPINDLE: on Valve operating class and to be used on valve class to fetch the same information. See below workaround to get the information as desired. In Class Editor, Open "O penPlant_3D.01.04.ecschema ” and supplement it with below schema. “ OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04.ecschema" Navigate to VALVE_OPERATING_DEVICE class & Add a new property, say SPINDLE. Add " Calculated ECProperty Specification " custom attribute under SPINDLE property. Add value as " SPINDLE: " and other field entries, like shown in below image. Navigate to VALVE class. Go to " Specific BOM Labels " Custom Attribute & change the expression as mentioned below. Name - IE_OPERATOR Value - this.GetRelatedInstance("VALVE_HAS_VALVE_OPERATING_DEVICE:0:VALVE_OPERATING_DEVICE").SPINDLE Save & Close Schema. Launch OpenPlant Isometrics Manager. Launch Configuration Manager. Go to Labels option. Set the value with upper case as DOWN & UP . Save settings. Generate isometrics with same style where changes are incorporated. Verify results. See below image. HTH, -Regards | Rahul Kumar
↧