I have done a lot of customisation of the OPIM Schema for Autoplant SS7. We have just upgraded to Autoplant SS8, and I have noticed the Schema versions are now different in SS8. I don't want to have to redo all the customisation all over again. Is there a way to use the old 01.04 schemas in SS8, or is there a way to merge the 01.04 with the 01.07 versions. These are the ones I have heavily customised for SS7 OPIM: OpenPlant_3D.01.04.ecschema OpenPlant_3D_Supplemental_Isometrics_Isoextractor.01.04.ecschema etc.... However the newer versions for SS8 are: OpenPlant_3D.01.07.ecschema OpenPlant_3D_Supplemental_Model_Server.01.07.ecschema etc..... I did copy all the relevant files from the previous SS7 project into the new SS8 project as I would normally do: From Source Project: Z:\W2\BENTLEY\PROJECTS\ABU DHABI GAS\Q11349\Config\OpenPlant\Isometrics\styles\Kharafi-IFC (which contains the cell & config sub-directories) To Destination Project: Z:\W2\BENTLEY\PROJECTS\ASME STANDARD\Config\OpenPlant\Isometrics\styles Result would be: Z:\W2\BENTLEY\PROJECTS\ASME STANDARD\Config\OpenPlant\Isometrics\styles\ Kharafi-IFC Customised “Schemas” in the source Project, as follows: From: Z:\W2\BENTLEY\PROJECTS\ABU DHABI GAS\Q11349\Config\OpenPlant\schemas To: Z:\W2\BENTLEY\PROJECTS\ASME STANDARD\Config\OpenPlant\schemas I always make a backup of the existing Schemas directory in the destination Project before I copy anything……just in case. Once copying has finished I test that all is working as it should. I usually have to tweak a few things here and there, depends on my customisation. But all the OPIM settings will transfer over seamlessly. However, this is from SS7 to SS7 projects where the Schema versions are the same. How do I get the SS7 customised Schema into the SS8 Schema?
↧