Applies To Product(s): OpenPlant Support Engineering Version(s): 08.11.11.235 (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Project Dashboard Subarea: Support Drawing Original Author: Rahul Kumar, Bentley Product Advantage Group Problem Description In OpenPlant Support Engineering, user requirement is to display dimension in various ways. With previous release of OpenPlant Support Engineering, value populated on Support drawing was as per below image shown. i.e. in Feet and decimal. User can display dimension using fraction and in various architectural units with the defined precision. Below steps would resolve such problems. Steps to Resolve Launch OpenPlant Support Engineering. Select OPModeler_Imperial here. Select working file and open. Attach an I model file as reference file. Place supports on a pipeline, say Pipe Clamp, Shoe and Rod with a weldless eye. See image below: From Support Engineering -> Project Dashboard. Go to Project parameters & Check variable FracPrecision . By default it is 1/16. From Tool Cabinet, click on Generate Support Drawing Manually. Select support and click ok to generate Support Drawing. See below drawing with pipe support and BOM. Dimension Rod Element to display a linear scale dimension using Support Drawing tab. Click carefully to dimension rod element. Check dimension with fractions. See below image. Still a Problem If there is still some problem, then please create a Service Request and contact Bentley Product Advantage group along with the list of all relevant details to get in depth analysis and for possible solution or workarounds. See Also Also refer Help file for new features and information regarding OpenPlant Support Engineering. Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧