Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX (SS5) | 08.11.11.XXX (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Iso Processing Subarea: I-Model Original Author: Deepak Singh, Bentley Product Advantage Group Problem Description I-model doesn’t load in OpenPlant Isometrics Manager. Progress bar in below dialog doesn't move further beyond this point and the process goes into loop. Reason User has created a new associated item for pipeline as “Lines Number” refer image below. Also, "Associated Item Relationship" custom attribute for this item is defined in supplemental schema as shown below. NOTE: The schema location for this custom attribute (Associated Item Relationship) must be in OpenPlant_3D.01.07 schema. Similarly check other classes like ASSOCIATED_ITEM_LIST_FOR_EQUIPMENT , ASSOCIATED_ITEM_LIST_FOR_HVAC_NETWORK_SYSTEM etc. and make sure that the above mentioned custom attribute is placed in primary schema only which is OpenPlant_3D. OpenPlant Modeler- OpenPlant Isometrics Manager Steps to Resolve Using Bentley Class Editor, open OpenPlant_3D.01.07 of your project. Supplement above schema with OpenPlant_3D_Supplemental_Modeling.01.07 & OpenPlant_3D_Supplemental_ModelingViews.01.07 schema. For More information on supplementing schema click here>>>> Also supplement custom schema OpenPlant_3D_Supplemental_AFW_Custom_Attributes.01.00 in which "Associated Item Relationship" custom attribute is placed. Supplemented schema list for OpenPlant_3D.01.07 are as shown below. Navigate to ASSOCIATED_ITEM_LIST_FOR_PIPING_NETWORK_SYSTEM class, switch to properties tab as shown below. Select newly associated item, here “LINENO” & scroll down to Associated Item Relationship custom attributes. Notice that schema location defined for this property is not in OpenPlant_3D as shown. Click on LINENO & select Custom Attributes > Add/Remove as shown below. Change schema location to OpenPlant_3D.01.07 as shown below. Save all the changes. Publish i-model again & load it in OpenPlant Isometrics Manager to verify the result. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!
↧