Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX Environment: Windows 7 (64 bit) Area: Open/Save Subarea: - Original Author: Harpreet Singh, Bentley Product Advantage Group Background By default, workspace root points to the default location of OpenPlant Modeler workspace which is C:\ProgramData\Bentley\OpenPlantModeler V8i\WorkSpace. However if modeler workspace is on shared location then OpenPlant Isometric Manager does not read the shared location. This article will explain the steps required to read the shared workspace. Steps to Accomplish Go to C:\Program Files (x86)\Bentley\OpenPlantIsometricsManager V8i\OpenPlantIsometricsManager\config folder. Open OPMdir.cfg file in notepad. Change the path for _USTN_INSTALLED_WORKSPACEROOT variable as highlighted in below picture. Save the changes and again launch OpenPlant Isometric Manager. It will read the workspace from shared location. Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧