Applies To Product(s): OpenPlant Isometrics Manager Version(s): 08.11.09.XXX Environment: Windows 7 (64 bit) & Others Area: Settings/Attributes Subarea: - Original Author: Rahul Kumar, Bentley Product Advantage Group Overview To provide Annotation on Components based on Property Value. Problem Solution Switching Property value should annotate accordingly.With a new Property, user wanted to control set of Flange, gasket & bolt to toggle ON/OFF on isometrics. Below are the steps to resolve such case using rep_sortgroups.txt file present inside the project style folder. Steps to resolve In class Editor, check for a property which is defined control Toggle ON/OFF. Say B_COMPLETE property. Define this property under Piping Component Class. Note - To create a new property under the class, user should refer related wiki present under Plant community. Launch OpenPlant Modeler. Assign property value based on Completion of project and are required to show it in Isometric labels & in BOM. Navigate to Style folder & rep_sortgroups.txt file. Open Rep_sortgroups.txt file and add below entry to it. SORTGROUP = FLANGE_1 HEADER = @ ----------- HEADER = @ FLANGE_1 HEADER = @ ----------- RULE = IE_TYPE=CT_FLANGE SKIP = 1 SORTGROUP = GASKET HEADER = @ ----------- HEADER = @ GASKET HEADER = @ ----------- RULE = IE_TYPE=CT_GASKET && B_COMPLETE = NO SORTGROUP = GASKET_1 HEADER = @ ----------- HEADER = @ GASKET_1 HEADER = @ ----------- RULE = IE_TYPE=CT_GASKET SKIP = 1 SORTGROUP = BOLT HEADER = @ ----------- HEADER = @ BOLT HEADER = @ ----------- RULE = IE_TYPE=CT_BOLT && B_COMPLETE = NO SORTGROUP = BOLT_1 HEADER = @ ----------- HEADER = @ BOLT_1 HEADER = @ ----------- RULE = IE_TYPE=CT_BOLT SKIP = 1 Launch OpenPlant Isometrics Manager & verify results. See Also Comments or Corrections? Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!
↧