I found some problems about olet. 1. Auto branch table is OK. If try to place a brach by snap to the main pipe, it will place the component defined in branch table. I did some test, if the main pipe length longer than 229 mm(branch start at the middle point), it works fine. If the main pipe length is shorter than 228 mm, no component will be placed automatically. 2. When generate ISO-sheet, the olet branch always be assigned to another iso sheet, even a very simple piping(main pipe + olet + branch pipe). If select the branch pipe components (branch pipe + olet) and try to move them to iso sheet 1, it will found disconnects and failed. If do "check connectivity" then, no disconnect found. 3. If auto generate ISO-sheet, there will be two iso sheets, sheet 1 is main pipe, sheet 2 is branch pipe + olet. In the iso drawing, no connecting informaiton will show. just like sheet 1 has nothing to do with sheet 2. OPM version: 08.11.09.568 OPIM version: 08.11.09.574
↧